How to Install a Hampton Bay Ceiling Fan

These instructions can change depending upon the model of Hampton Bay ceiling fan that you pick. For the best instruction set, you should refer to the manual and/or instructions that came with your fan. That is always the best way to go about. In the event you cannot find the original documentation that came with the fan purchase, then try taking a look on Google for your model. Not sure of your model? You can find it on the bottom housing or sometimes inside of the housing of the fan.

The below instructions are a general instruction for installing a Hampton Bay fan.

Part 1 – Installation of the Mounting for the Ceiling Fan

You’ll want to slowly loosen the two screws, that reside on top of the motor assembly. These are in the “collar” which is a circle that actually looks like
a collar.

Next you’ll want to remove the canopy ring. This is done by turning the right to the right. After doing this, and unscrewing the canopy ring, it will unlock.

The next step is to remove the mounting plate. The mounting plate is on the top of the canopy. You’ll want to loosen the four screws here.

Once that’s done, the non-slotted screws should be removed by a screwdriver. You can then remove the mounting plate.

Installation Instructions for a Hampton Bay San Marino Ceiling Fan

The below instructions are in point form. They were made while installing a Hampton Bay San Marino ceiling fan. Some of this information may be useful for installing other ceiling fans as well – not just the San Marino, as many installation steps are generic amongst Hampton Bay fans.

  • Lot of parts and assembly
  • Make sure there is reinforcement in the ceiling mount (inside of the ceiling)
  • Wood grain facing down position
  • Avoid using power tools on rubber parts, such as impact gun
  • Use a hand screw driver for most of the major assembly
  • Put the blades onto the housing and fasten using screws
  • Check when assembling that not skipping parts
  • Ensure the mounting hole in ceiling has all parts – nothing stripped or missing
  • If installing with the lights, attach the light holder assembly
  • 2 wires for hooking up the power – should be straight forward to avoid polarity issues
  • Pullchains get hooked up near the end of the installation

Installing the Light kit

    • Remove packaging screws
    • When putting light kit together, may need to remove some screws in order to get the housing together
    • Don’t use serious force on the light kit housing or it could break
    • For this ceiling fan, there were three (3) screws on the outside of the light kit. When tightening the screws, it was more effective
      to tighten the screws after all three were in place.
    • Try to keep the fan balanced so there is no fan wobble at all when the fan is moving.

Mounting the Fan to the Ceiling

      • 2/4 screws were removed in this installation as two of the screws were for packaging only. It was easier to install the mounting with the two remaining scews.
      • Try to keep the washers where they are

Installation instructions for Hampton Bay Dual Mount Light Fixtures

This dual use light kit can work in two ways. The first way is, the light kit can attach directly to the ceiling. The second method,
is it can attach to a ceiling fan directly.

Warning messages:

      • Turn off the electricity at the circuit breaker before beginning installation, in order to not get electrocuted!
      • Wiring should be completed to the National Electric Code, and local electrical codes. Wiring should be completed
        by a technician or electrician who is certified.
      • Fixture requires mounting to an approved outlet box that is wired directly into the building.
      • This light kit will only work with fans that have a center plug in the switchcap. This includes the Hampton Bay Farmington and Huntington ceiling fans.